القائمة
Use when a receiver runs but produces no output, noise, or the wrong result — systematically locate the fault instead of guessing, using render and measure to see the problem.
التثبيت باستخدام Codex أو Claude انسخ هذا Prompt والصقه في Codex أو Claude أو مساعد آخر ليراجع صفحة Skill ويثبّتها لك.
استنادا إلى تصنيف SOC المهني
Use when the user wants to receive or demodulate a specific signal — build, validate, run, and verify a receiver pipeline, then save it as a reusable, GRC-openable flowgraph.
Use ONLY as a last resort when no Marconi tool or vocabulary block can express the task — write a Python script against the marconi library, run it, and report the capability gap.
Use when the user wants a test signal or a simulated RF environment with no hardware — translate intent into a scene and register it as a persistent simulated device.
Use when the user wants to know what signals are present — characterize a capture or a simulated device's spectrum (PSD, signal detection, spectrogram) and summarize what's on the air.
Use when the user wants a closed-loop transmit-then-receive experiment in simulation — transmit a capture into a simulated device's scene and receive it back to confirm the link.
| name | debug-no-signal |
| description | Use when a receiver runs but produces no output, noise, or the wrong result — systematically locate the fault instead of guessing, using render and measure to see the problem. |
A receiver that runs status: ok but produces silence or garbage has a DSP fault, not a crash. Find it systematically; do not randomly tweak parameters.
spectrogram (and/or psd_plot) of the channelized capture — the stage right after freq_xlating_lowpass — and measure it. Most faults are visible there.center_offset value or its sign is wrong (center_offset = target_freq − capture_center_freq).quad_rate. Check sample_rate / decimation.cutoff below the signal bandwidth clips it (muffled/silent); far too wide lets in neighbors (noisy).measure the channelized capture: very low SNR means you channelized empty spectrum — re-check the target frequency from survey-spectrum.nbfm_rx, quad_rate must be an integer multiple of audio_rate; a wav_sink sample_rate must match the audio stream rate.