| name | toybridge |
| description | Control any BLE toy that has been reverse-engineered and connected via the ToyBridge server. Calls a local HTTP API to send vibrate/stop commands. Requires the ToyBridge server running on the same machine. |
| metadata | {"openclaw":{"os":["darwin"]}} |
ToyBridge — Universal BLE Toy Control
Control any BLE toy through OpenClaw, as long as you have the ToyBridge server running.
This skill is for devices that are not supported by Buttplug.io/Intiface — devices with proprietary or unknown protocols that you've reverse-engineered yourself using the ToyBridge toolkit.
If your device IS supported by Buttplug.io, use the intiface-control skill instead — it's easier.
Prerequisites
- You've reverse-engineered your device's BLE protocol using ToyBridge
- You've configured
4-bridge/ble_worker.py for your device
- The ToyBridge server is running:
uv run 4-bridge/server.py
See the full setup guide for step-by-step instructions.
Commands the agent will use
Vibrate at intensity
curl -s -X POST http://host.docker.internal:8888/vibrate \
-H "Content-Type: application/json" \
-d '{"intensity": 60}'
intensity: 0–100 (0 = stop)
Stop immediately
curl -s -X POST http://host.docker.internal:8888/stop
Check status
curl -s http://host.docker.internal:8888/status
If OpenClaw runs natively (not in Docker), replace host.docker.internal with localhost.
Intensity guide
| Range | Feel |
|---|
| 1–20 | Gentle |
| 30–50 | Medium |
| 60–80 | Strong |
| 90–100 | Maximum |
Preset patterns
| Pattern | What it does |
|---|
pulse | Bursts of 80%, 5 times |
wave | Ramp up 20→100%, then back down, x2 |
tease | 30% → 70% → 100%, escalating, then stop |
To run a pattern:
curl -s -X POST http://host.docker.internal:8888/vibrate \
-H "Content-Type: application/json" \
-d '{"pattern": "wave"}'
Agent rules
- Always stop (intensity 0) after a timed session unless user says to keep going
- Do not use the
notify tool — use bash with curl
- Replace
host.docker.internal with localhost if OpenClaw is not in Docker
Troubleshooting
| Problem | Fix |
|---|
connection refused | Make sure uv run 4-bridge/server.py is running |
| Device doesn't respond | Check your device config in ble_worker.py |
| Wrong intensity | Values are clamped to 0–100 |
