cis-ubuntu2004-v300-3-3-5

name	cis-ubuntu2004-v300-3-3-5
description	Ensure icmp redirects are not accepted
category	cis-networking
version	3.0.0
author	cyberstrike-official
tags	["cis","ubuntu","linux","ubuntu-20.04","kernel-parameter"]
cis_id	3.3.5
cis_benchmark	CIS Ubuntu Linux 20.04 LTS Benchmark v3.0.0
tech_stack	["ubuntu","linux"]
cwe_ids	[]
chains_with	[]
prerequisites	[]
severity_boost	{}

3.3.5 Ensure icmp redirects are not accepted (Automated)

Profile

• Level 1 - Server
• Level 1 - Workstation

Description

ICMP redirect messages are packets that convey routing information and tell your host (acting as a router) to send packets via an alternate path. It is a way of allowing an outside routing device to update your system routing tables.

Rationale

ICMP redirect messages are packets that convey routing information and tell your host (acting as a router) to send packets via an alternate path. It is a way of allowing an outside routing device to update your system routing tables. By setting net.ipv4.conf.all.accept_redirects, net.ipv4.conf.default.accept_redirects, net.ipv6.conf.all.accept_redirects, and net.ipv6.conf.default.accept_redirects to 0, the system will not accept any ICMP redirect messages, and therefore, won't allow outsiders to update the system's routing tables.

Impact

None expected.

Audit Procedure

Command Line

Run the following script to verify the following kernel parameters are set in the running configuration and correctly loaded from a kernel parameter configuration file:

• net.ipv4.conf.all.accept_redirects is set to 0
• net.ipv4.conf.default.accept_redirects is set to 0
• net.ipv6.conf.all.accept_redirects is set to 0
• net.ipv6.conf.default.accept_redirects is set to 0

Note:

• kernel parameters are loaded by file and parameter order precedence. The following script observes this precedence as part of the auditing procedure. The parameters being checked may be set correctly in a file. If that file is superseded, the parameter is overridden by an incorrect setting later in that file, or in a canonically later file, that "correct" setting will be ignored both by the script and by the system during a normal kernel parameter load sequence.
• IPv6 kernel parameters only apply to systems where IPv6 is enabled

Expected Result

Audit Result: ** PASS ** with all four accept_redirects parameters set to 0 (or IPv6 parameters not applicable if IPv6 is disabled).

Remediation

Command Line

Set the following parameters in /etc/sysctl.conf or a file in /etc/sysctl.d/ ending in .conf:

• net.ipv4.conf.all.accept_redirects = 0