메뉴
Use when working on Simulink or Simscape Electrical renewable and grid-connected power-electronics systems, including PV, wind, storage-coupled inverters, microgrids, MPPT, PLL, grid synchronization, and grid-code validation.
Codex 또는 Claude로 설치 이 Prompt를 복사해 Codex, Claude 또는 다른 어시스턴트에 붙여 넣으면 Skill 페이지를 검토하고 설치를 진행할 수 있습니다.
SOC 직업 분류 기준
Use when working on Simulink or Simscape Electrical power-electronics models, including inverter, DC-DC converter, rectifier, motor-drive, battery/BMS, renewable-grid, HVDC/FACTS, converter layout, gate-routing, solver, waveform, control-algorithm, or simulation validation tasks.
Use when working on Simulink or Simscape Electrical DC-DC converter models, including buck, boost, buck-boost, flyback, forward, resonant, bidirectional converters, MPPT front ends, duty-cycle control, and regulation diagnostics.
Use when working on Simulink or Simscape Electrical motor-drive power-electronics models, including PMSM, BLDC, induction motor drives, FOC, DTC, torque/speed/current loops, inverter-fed machines, and drive waveform validation.
Use when working on Simulink or Simscape Electrical three-phase grid-connected inverter models, including SPWM/SVPWM, T-type or NPC three-level bridges, grid-side voltage/current waveform balance, gate routing, sector tables, and switching-state validation.
Use when working on Simulink or Simscape Electrical battery, charger, and BMS-linked power-electronics models, including pack behavior, balancing, SOC/SOH, bidirectional charging, protection, and storage converter interfaces.
Use when working on Simulink or Simscape Electrical HVDC and FACTS models, including VSC-HVDC, LCC-HVDC, STATCOM, SVC, UPFC, transmission-system controls, power-flow regulation, and grid disturbance studies.
| name | renewable-grid-systems |
| description | Use when working on Simulink or Simscape Electrical renewable and grid-connected power-electronics systems, including PV, wind, storage-coupled inverters, microgrids, MPPT, PLL, grid synchronization, and grid-code validation. |
Stub. Use this file only to recognize renewable/grid-system scope and choose evidence to collect. Apply the root workflow and any active converter subskill that matches the plant; grid-code and PLL checks are not yet fully specified here.
Promote only after adding references and checks for synchronization, power flow, grid disturbances, ride-through behavior, and representative renewable-source dynamics.
