메뉴
Resolve the exact ALPS EC11L1525G01 rotary encoder used on Board L. Use for quadrature phase order, detents, switch terminals, mechanical drawing, soldering, lifetime, lifecycle uncertainty, and encoder-interface questions.
기본적으로 소스를 먼저 확인하는 Prompt가 선택됩니다. 직접 명령으로 전환하거나 로컬 사본을 다운로드할 수도 있습니다.
설치 여부를 결정하기 전에 SKILL.md와 SkillsMP에 표시된 보조 파일을 읽어 보세요.
Codex 또는 Claude로 설치 이 Prompt를 복사해 Codex, Claude 또는 다른 어시스턴트에 붙여 넣으면 Skill 페이지를 검토하고 설치를 진행할 수 있습니다.
직접 명령은 검토 Prompt를 거치지 않습니다. 실행하기 전에 소스를 확인하세요.
npx skills add https://github.com/Takazudo/zudo-led-lamp --skill component-alps-ec11l1525g01명령은 한 줄로 유지됩니다. 복사하기 전에 가로로 스크롤해 전체 내용을 확인하세요.
로컬 사본을 원하시나요? SkillsMP에서 현재 제공할 수 있는 파일을 다운로드하세요.
SKILL.md 표시 중
Audit exact electronic-component identities and run the end-to-end workflow for adding or replacing a BOM part. Use whenever circuit, schematic, PCB, BOM, firmware, bring-up, substitution, or related documentation could depend on a component rating, pin, package, source, preview, publication, or interaction.
Resolve exact EXAMPLE-MPN component limits and application constraints. Use whenever EXAMPLE-MPN, its LCSC ID, manufacturer, function, pins, package, substitution, bring-up, or firmware behavior is relevant.
Navigation design rules for the zudo-led-lamp doc site (zudo-doc). Consult before creating new pages, restructuring directories, or changing header navigation. Covers: 3-level hierarchy (header → sidebar → nested), file-structure-is-navigation principle, header nav conciseness, category index pages, sidebar_position discipline, the generated claude* categories, and common mistakes. Triggered by 'nav design', 'navigation structure', 'zudo-doc-navigation-design', 'structure nav', 'add category', 'add header nav', 'add a doc page'.
| name | component-alps-ec11l1525g01 |
| description | Resolve the exact ALPS EC11L1525G01 rotary encoder used on Board L. Use for quadrature phase order, detents, switch terminals, mechanical drawing, soldering, lifetime, lifecycle uncertainty, and encoder-interface questions. |
Run the central validator and read all local JSON before using this record. The retained specification is manufacturer-authored but hosted by a mirror, so every specification claim is intentionally UNVERIFIED/UNSOURCED. The current ALPS product page was inaccessible and cannot substantiate lifecycle status. A 2026-08-02 retry confirms this is not a generic bot block: the sibling EC11E15244G1 detail page loads normally with the same client, but EC11L1525G01 returns HTTP 403 on every path (including the alps.com legacy redirect target) and no EC11L series appears in any current encoder sub-category listing — the exact model looks to have been withdrawn from Alps Alpine's current online catalog.
The retained mirror identifies 15 pulses and 30 detents, while the generator display says “15-detent.” Treat this as an UNSOURCED documentation discrepancy until manufacturer-primary bytes are locked. A and B are phase contacts referenced to common C; D/E are the momentary push-switch terminals and are unused on this board. Pins 6/7 are grounded mechanical/electrical support lugs in the project footprint.
Use the retained chatter, bounce, torque, life, shaft, panel-support, and solder-process facts only with their stated conditions. Firmware debounce, direction convention at the UI, installed knob load, panel support, switch use, lifecycle status, and bench behavior remain open.
The design's real operating point differs from every retained spec condition: V3P3's 10 kOhm pull-up (R22/R23) gives roughly 0.33 mA closed-contact current versus the retained 5 V/5 kOhm chatter-bounce test circuit, and the only retained minimum-current spec (500 uA) belongs to the unused D/E push switch, not the A/B/C rotary contacts. C22/C23 100 nF at ENC_A/ENC_B discharge through R27/R28 100 Ohm at roughly 33 mA peak with no retained contact-current rating. Bench debounce/contact verification at the real 3.3 V/10k operating point is required before this domain closes.
Human projection of this bundle: rec-c2991196. Those pages are generated from the JSON files here and add nothing to them — where the two disagree, this bundle is correct. See also the component catalog and the cross-component rules.