菜单
Read MIKE+ .res1d results via the mike-plus MCP server — list contents, summarize peaks, or extract a single time series. Use when an agent needs to inspect or pull numbers from MIKE+ network results (node water levels, link/reach discharge, velocities). No MIKE+ license or installation required.
用 Codex 或 Claude 帮你安装 复制这段 Prompt，粘贴到 Codex、Claude 或其他助手里，让它检查 Skill 页面并帮你完成安装。
基于 SOC 职业分类
Inspect a MIKE+ .sqlite model via the mike-plus MCP server — active simulation/scenario/model, unit system, the list of simulation setups and scenarios, and element counts. Use when an agent needs to understand a MIKE+ model before running or editing it. Requires MIKE+ installed + a license.
Read and modify MIKE+ model parameters via the mike-plus MCP server — inspect or change values in any model table (pipe Diameter/Manning in msm_Link, node levels in msm_Node, catchment properties in msm_Catchment, etc.). Use when an agent must identify a current parameter and change it before re-running. Requires MIKE+ + license; mutating tools must run on a copy.
Produce publication-style figures from MIKE+ .res1d results via the mike-plus MCP server — a stacked rainfall-runoff hydrograph or a single time series, in the house style (Arial 12, ticks inward, SI units, no title). Use when an agent must render MIKE+ results as a PNG without opening the GUI. No license required.
Run MIKE+ simulations headless via the mike-plus MCP server and report result files + engine status. Use when an agent must execute a MIKE+ .sqlite model's active (or a named) simulation without opening the MIKE+ GUI, then hand the .res1d outputs to reading/plotting. Requires MIKE+ installed + a valid license. Always run on a copy.
| name | mike-results |
| version | 0.1.0 |
| description | Read MIKE+ .res1d results via the mike-plus MCP server — list contents, summarize peaks, or extract a single time series. Use when an agent needs to inspect or pull numbers from MIKE+ network results (node water levels, link/reach discharge, velocities). No MIKE+ license or installation required. |
Reads MIKE+ .res1d result files (via mikeio1d). No license / no MIKE+ install needed — fully portable.
To find out what is in a result file, get peak values, or extract a series for analysis/plotting. Use after mike_run, or on any existing .res1d.
mike_results_list — {res1d} → quantities, element counts + sample ids (nodes/reaches/structures/catchments), time range. Start here to discover valid quantity/element values.mike_results_summary — {res1d, quantities?} → per-quantity peak (value, element, chainage, time), in the canonical schema.mike_results_read — {res1d, quantity, element, max_points?} → a single downsampled time series (times, values, unit).Quantity:ElementId[:chainage] (e.g. Discharge:Link_29:33.5333). element matches the id prefix.{engine, quantity, element_id, chainage, unit, ...}) so the same downstream skills work for SWMM/LSTM later. (mike_results_summary reports the peak's element as peak_element — same idea, named for the peak.)mike_results_summary returns the max over the WHOLE run, which can land in the warm-up / initial-condition period (e.g. a base-flow value near t=0), not the storm peak. Always check peak_time; when you want the event peak, pass skip_hours (e.g. skip_hours: 6) to drop the initial window.quantity/element has no series, say so (the tool errors with a clear message) rather than guessing.mike_results_list -> learn quantities + element ids
mike_results_summary -> peaks for a quick read
mike_results_read -> a series for a specific element -> mike-plot