protocol-analyzer

name	protocol-analyzer
description	Serial protocol analysis and debugging for common embedded interfaces (I2C, SPI, UART)
category	Communication Protocols
allowed-tools	["Bash","Read","Write","Edit","Glob","Grep"]

Protocol Analyzer Skill

Overview

This skill provides serial protocol analysis and debugging capabilities for common embedded communication interfaces including I2C, SPI, and UART.

Capabilities

I2C Analysis

• Bus address detection and scanning
• Transaction decoding and timing
• NACK handling and error detection
• Multi-master arbitration analysis
• Clock stretching detection
• 7-bit and 10-bit addressing
• Fast mode and fast mode plus support

SPI Analysis

• Transaction decoding
• Mode configuration (CPOL/CPHA)
• Clock frequency analysis
• Chip select timing verification
• Full-duplex data capture
• Multi-slave configurations

UART Analysis

• Frame analysis and decoding
• Baud rate auto-detection
• Parity and stop bit verification
• Flow control analysis (RTS/CTS)
• Break condition detection
• Error frame identification

Timing Analysis

• Setup and hold time verification
• Clock frequency measurement
• Inter-frame timing analysis
• Protocol timing compliance
• Glitch and noise detection

Integration

• Saleae Logic analyzer integration
• Sigrok/PulseView support
• Protocol decoder libraries
• Export to standard formats

Target Processes

• device-driver-development.js - Driver debugging and validation
• hardware-bring-up.js - Initial communication verification
• signal-integrity-testing.js - Protocol signal analysis
• bsp-development.js - BSP communication testing

Dependencies

• Logic analyzer software (Saleae Logic, Sigrok)
• Protocol decoder libraries
• Logic analyzer hardware

Usage Context

This skill is invoked when tasks require:

• Serial protocol debugging
• Communication timing verification
• Bus error diagnosis
• Protocol compliance testing
• Multi-device communication analysis

Protocol Configurations

I2C Standard Settings

i2c:
  mode: standard | fast | fast_plus | high_speed
  addressing: 7bit | 10bit
  clock_stretching: enabled | disabled

SPI Mode Settings

spi:
  mode: 0 | 1 | 2 | 3  # CPOL/CPHA combinations
  bit_order: msb_first | lsb_first
  word_size: 8 | 16 | 32

UART Settings

uart:
  baud_rate: 9600 | 115200 | etc.
  data_bits: 7 | 8 | 9
  parity: none | even | odd
  stop_bits: 1 | 2