arduino-run

name	arduino-run
description	Compile the Digispark sketch and flash it to the board in one step (compile then upload) via arduino-cli/mise. Use when the user wants to build and run/flash the firmware. Flashes physical hardware — confirm the right board is connected first, and note the Digispark must be plugged in when prompted (portless micronucleus bootloader).
argument-hint	[--port <port>]

Arduino: compile and upload (run)

Run mise run arduino:run to compile the sketch and then flash it to the board. This chains arduino:compile → arduino:upload.

Usage

mise run arduino:run                 # stock Digispark: plug it in when prompted
mise run arduino:upload --port /dev/ttyACM0   # only for non-micronucleus boards

Instructions

1. Parse $ARGUMENTS. The only optional arg is --port, which is forwarded to arduino:upload and is normally unset for a micronucleus Digispark.
2. This flashes physical hardware. Confirm the intended board is the one connected ($ARDUINO_FQBN in .env.yaml) before flashing.
3. Run mise run arduino:run (or mise run arduino:upload [--port …] if only the upload step is wanted). For a stock Digispark, tell the user to connect/replug the board when arduino-cli prints "Please plug in the device".
4. Report the compile result and the upload result.