メニュー
Use when working on Simulink or Simscape Electrical multilevel converter models beyond the populated three-phase inverter notes, including MMC, cascaded H-bridge, flying-capacitor converters, capacitor balancing, and arm-energy control.
Codex または Claude でインストール この Prompt をコピーして Codex、Claude、または他のアシスタントに貼り付けると、Skill ページを確認してインストールできます。
SOC 職業分類に基づく
Use when working on Simulink or Simscape Electrical power-electronics models, including inverter, DC-DC converter, rectifier, motor-drive, battery/BMS, renewable-grid, HVDC/FACTS, converter layout, gate-routing, solver, waveform, control-algorithm, or simulation validation tasks.
Use when working on Simulink or Simscape Electrical DC-DC converter models, including buck, boost, buck-boost, flyback, forward, resonant, bidirectional converters, MPPT front ends, duty-cycle control, and regulation diagnostics.
Use when working on Simulink or Simscape Electrical motor-drive power-electronics models, including PMSM, BLDC, induction motor drives, FOC, DTC, torque/speed/current loops, inverter-fed machines, and drive waveform validation.
Use when working on Simulink or Simscape Electrical three-phase grid-connected inverter models, including SPWM/SVPWM, T-type or NPC three-level bridges, grid-side voltage/current waveform balance, gate routing, sector tables, and switching-state validation.
Use when working on Simulink or Simscape Electrical battery, charger, and BMS-linked power-electronics models, including pack behavior, balancing, SOC/SOH, bidirectional charging, protection, and storage converter interfaces.
Use when working on Simulink or Simscape Electrical HVDC and FACTS models, including VSC-HVDC, LCC-HVDC, STATCOM, SVC, UPFC, transmission-system controls, power-flow regulation, and grid disturbance studies.
| name | multilevel-mmc |
| description | Use when working on Simulink or Simscape Electrical multilevel converter models beyond the populated three-phase inverter notes, including MMC, cascaded H-bridge, flying-capacitor converters, capacitor balancing, and arm-energy control. |
Stub. Use this file only to recognize broader multilevel/MMC scope and choose evidence to collect. The active inverter subskill covers only its populated T-type/NPC three-level SVPWM notes.
Promote only after adding representative MMC or broader multilevel workflows, validated modulation references, and checks for submodule states, balancing, and arm energy.
