메뉴
Use when working on Simulink or Simscape Electrical rectifier or active-front-end models, including diode and thyristor rectifiers, PWM rectifiers, PFC, DC-link regulation, line-current quality, and regeneration.
Codex 또는 Claude로 설치 이 Prompt를 복사해 Codex, Claude 또는 다른 어시스턴트에 붙여 넣으면 Skill 페이지를 검토하고 설치를 진행할 수 있습니다.
SOC 직업 분류 기준
Use when working on Simulink or Simscape Electrical power-electronics models, including inverter, DC-DC converter, rectifier, motor-drive, battery/BMS, renewable-grid, HVDC/FACTS, converter layout, gate-routing, solver, waveform, control-algorithm, or simulation validation tasks.
Use when working on Simulink or Simscape Electrical DC-DC converter models, including buck, boost, buck-boost, flyback, forward, resonant, bidirectional converters, MPPT front ends, duty-cycle control, and regulation diagnostics.
Use when working on Simulink or Simscape Electrical motor-drive power-electronics models, including PMSM, BLDC, induction motor drives, FOC, DTC, torque/speed/current loops, inverter-fed machines, and drive waveform validation.
Use when working on Simulink or Simscape Electrical three-phase grid-connected inverter models, including SPWM/SVPWM, T-type or NPC three-level bridges, grid-side voltage/current waveform balance, gate routing, sector tables, and switching-state validation.
Use when working on Simulink or Simscape Electrical battery, charger, and BMS-linked power-electronics models, including pack behavior, balancing, SOC/SOH, bidirectional charging, protection, and storage converter interfaces.
Use when working on Simulink or Simscape Electrical HVDC and FACTS models, including VSC-HVDC, LCC-HVDC, STATCOM, SVC, UPFC, transmission-system controls, power-flow regulation, and grid disturbance studies.
| name | rectifiers-active-front-ends |
| description | Use when working on Simulink or Simscape Electrical rectifier or active-front-end models, including diode and thyristor rectifiers, PWM rectifiers, PFC, DC-link regulation, line-current quality, and regeneration. |
Stub. Use this file only to recognize rectifier/AFE scope and choose evidence to collect. Apply the root workflow; this is not yet a populated rectifier or PFC methodology.
Promote only after adding rectifier/PFC references, representative validation windows, and checks for line current, power factor, DC-link ripple, and switching legality.
