hinge：控制可折叠 iPhone 模拟器的铰链

# hinge Set and read the hinge angle of a booted foldable iPhone Simulator from the command line. It posts the same HID event as the hidden hinge slider in Xcode's Device Hub (hold Option). Run the bundled script at `scripts/hinge`, relative to this skill's directory. If `hinge` is on `PATH`, you can use that instead. ## Commands ```bash scripts/hinge 120 # set angle: 0 = closed, 180 = flat scripts/hinge open # 180° scripts/hinge close # 0° scripts/hinge half # 90° scripts/hinge sweep 180 0 2 # animate from 180° to 0° over 2 seconds scripts/hinge get # print current angle, e.g. 130.0 scripts/hinge posture # angle, orientation, and which integrated display is active scripts/hinge rotate left # rotate 90°, like Device Hub's Controls > Rotate Left; prints the new orientation scripts/hinge rotate right scripts/hinge orient landscape-left # portrait, landscape-left, landscape-right, or portrait-upside-down scripts/hinge orientation # print current orientation, e.g. landscape-left scripts/hinge -d "iPhone Duo" 90 # target a simulator by name or UDID (default: booted) scripts/hinge -t 0 90 # set without waiting for the angle to be confirmed ``` `open`, `close` and `half` also accept `unfolded`/`flat`, `closed`/`folded` and `half-open`. ## Workflow 1. Make sure a foldable simulator is booted: `xcrun simctl list devices booted`. 2. Set the angle. The command returns once the simulator reports the new angle, so a non-zero exit means the fold did not happen — don't poll `get` to check it. 3. Wait about half a second before you screenshot or read the UI: the display switch takes 1-2.5 s after the angle changes. 4. `scripts/hinge posture` tells which display hosts the UI (`active`) after a fold. 5. Screenshots: `xcrun simctl io booted screenshot out.png`. For the outer display, add `--display=1`. ## Notes - Simulator only. It does not work on physical devices. - The first run compiles a tiny helper with Xcode's clang, caching it under `~/.cache/hinge`. It takes a few seconds. - A `sweep` runs at 60 Hz in one process. For a smooth animation, use it instead of many `set` calls. It does not confirm the final angle. - Only 0° and 180° reliably switch the active display. At angles in between, the result depends on the path the hinge took, so a slow `sweep` can keep the previous display active until the end. To be sure a display switched, set 0° or 180° and check `posture`. - Angles outside 0-180 are rejected. A simulator without a hinge fails with "this simulator reports no hinge". - `orient`, `orientation` and `rotate` use device orientations (the `devicectl` names), not interface orientations: a device in `landscape-right` shows a `landscape-left` interface. - Orientation on a foldable follows only Device Hub's own event; `xcrun devicectl device orientation set` reports success there but is reverted. `rotate`/`orient` send Device Hub's event and fall back to `devicectl` on simulators that ignore it. - This uses a private, undocumented protocol. It was verified with Xcode 27.1 and iOS 27.1 and may break in other versions. If setting an angle fails with "the hinge angle did not reach ...", report that the protocol has likely changed.