can-bus-modules

name	can-bus-modules
description	CAN Bus interfacing for automotive/industrial networks using MCP2515 over SPI, baud rates, reading OBD-II frames.

can-bus-modules

Goal: Interface microcontrollers with automotive and industrial Controller Area Networks (CAN) using transceivers to read and spoof packets.

1. Hardware Stack

• MCU: e.g., Arduino or ESP32.
• Controller: MCP2515 (Translates SPI from MCU into CAN format). Maintains transmit buffers and acceptance filters.
• Transceiver: TJA1050 or MCP2551 (Translates logic-level CAN from the MCP2515 into the differential CAN_H and CAN_L analog voltages required by the physical bus).
• Physical Bus: CAN_H and CAN_L twisted pair. Requires 120-ohm termination resistors at both ends of the bus.

2. Setting Baud Rates & Oscillators

The CAN bus relies entirely on timing. Connecting with the wrong speed brings down the bus (Error Passive).

• Standard OBD-II in vehicles uses 500 kbps.
• Slower comfort buses (doors, windows) might use 125 kbps or 250 kbps.
• Make sure you initialize the library with the exact crystal oscillator speed attached to your MCP2515 board (commonly 8 MHz or 16 MHz).

3. Standard vs Extended Frames

• Standard Frame: 11-bit ID. (e.g., 0x7DF). Used heavily in standard automotive.
• Extended Frame: 29-bit ID. (e.g., 0x18DAF100). Often seen in heavy duty (J1939) or specialized sensors.
• Payload is always 0 to 8 bytes.

4. Code Snapshot (mcp_can library)

#include <SPI.h>
#include <mcp_can.h>

const int spiCSPin = 10;
MCP_CAN CAN(spiCSPin);

void setup() {
    Serial.begin(115200);
    // Initialize exactly for 500k baud and 8MHz crystal
    while (CAN_OK != CAN.begin(CAN_500KBPS, MCP_8MHz)) {
        Serial.println("CAN init fail, retry...");
        delay(100);
    }
    Serial.println("CAN init ok!");
}

void loop() {
    long unsigned int rxId;
    unsigned char len = 0;
    unsigned char rxBuf[8];

    if (CAN_MSGAVAIL == CAN.checkReceive()) {
        CAN.readMsgBuf(&rxId, &len, rxBuf);
        Serial.print("ID: "); Serial.print(rxId, HEX);
        Serial.print(" Data: ");
        for(int i = 0; i<len; i++) {
            Serial.print(rxBuf[i], HEX); Serial.print();
        }
        Serial.();
    }
}