Skip to main content

elevators-vertical-transportation

Elevator and escalator systems guidance for construction project managers coordinating vertical transportation installation.

설치로 이동

소스 정보

저장소
Construction-Gamma/construction-gamma-skills
최근 소스 활동
2026년 2월 28일 12:02
감지된 SKILL.md 언어
영어
스타
11
포크
5

설치 방법

기본적으로 소스를 먼저 확인하는 Prompt가 선택됩니다. 직접 명령으로 전환하거나 로컬 사본을 다운로드할 수도 있습니다.

소스 파일 검토

설치 여부를 결정하기 전에 SKILL.md와 SkillsMP에 표시된 보조 파일을 읽어 보세요.

파일 탐색기
20 개 파일

SKILL.md 표시 중

SKILL.md
소스 지침 · 읽기 전용 미리보기
name
elevators-vertical-transportation
description
Elevator and escalator systems guidance for construction project managers coordinating vertical transportation installation.
# Elevators & Vertical Transportation Quick reference for construction project managers and field supervisors managing elevator and escalator installations on commercial and institutional projects. ## Elevator Type Selection | Type | Speed | Rise | Best Application | |------|-------|------|------------------| | Geared Traction | Up to 350 fpm | Unlimited | Low/mid-rise, moderate traffic | | Gearless Traction | 500+ fpm | Unlimited | High-rise, high-speed, heavy traffic | | MRL (Machine-Room-Less) | Up to 500 fpm | Low/mid-rise | Space savings, no machine room above | | Hydraulic (Conventional) | 150-200 fpm | 60-70 ft | Low-rise, cost-effective | | Hydraulic (Holeless) | 150-200 fpm | 40-50 ft | Low-rise, no ground penetration | | LULA | 30 fpm | Per code | Accessibility, small buildings | ## Standard Elevator Capacities | Capacity | Platform Size (Typical) | Application | |----------|------------------------|-------------| | 2,500 lbs | 6'-8" x 4'-3" | Standard office passenger | | 3,000 lbs | 6'-8" x 4'-5" | Office, retail | | 3,500 lbs | 7'-0" x 5'-0" | Hospital, hotel | | 4,000-4,500 lbs | 8'-4" x 5'-8" | Hospital bed elevator | | 5,000+ lbs | Varies | Freight, service | ## Critical Coordination Points ### Structural Requirements - **Pit depth**: 4'-6" to 8' (traction), 4'-0" to 5'-0" (hydraulic) - **Overhead clearance**: 12'-0" to 16'-0" minimum (varies by speed) - **Hoistway dimensions**: ±½" tolerance on width and depth - **Plumbness**: 1:500 maximum deviation - **Rail bracket loads**: 10,000-25,000 lbs horizontal per bracket ### Electrical Requirements - **Power**: 208V or 480V, 3-phase (verify with manufacturer) - **Dedicated feeder**: Required for each elevator - **Disconnect**: Lockable, within sight of machine - **Machine room lighting**: 100 ft-candles minimum - **Pit and hoistway**: Lighting and GFCI receptacle required ### Fire Protection Interface - **Smoke detectors**: Lobby, machine room, hoistway (top) - **Phase I recall**: Automatic on smoke detection - **Shunt trip**: Required if hoistway sprinklered - **Fire alarm integration**: Addressable or relay interface ## Pre-Installation Checklist | Item | Verify | Responsible | |------|--------|-------------| | Pit complete and waterproofed | Dimensions, drain, ladder, light | GC/Structural | | Hoistway enclosed and fire-rated | Dimensions, plumb, brackets set | GC/Structural | | Machine room ready | Dimensions, ventilation, power | GC/Electrical | | Power available | Voltage, phase, amperage | Electrical | | Fire alarm interface ready | Smoke detectors, recall circuits | Fire Alarm | | Hoistway openings framed | Headers, dimensions, fire rating | GC | ## Installation Sequence 1. **Pre-installation inspection** - Verify pit, hoistway, machine room complete 2. **Rail installation** - Brackets, templates, rails, alignment 3. **Machine installation** - Setting, connections, alignment 4. **Car installation** - Platform, frame, guide shoes 5. **Hoistway doors** - Frames, doors, hardware 6. **Wiring and controls** - Traveling cable, controller commissioning 7. **Cab finishes** - Interior panels, flooring, fixtures 8. **Adjustments and testing** - Fine-tuning, safety tests 9. **Inspection and acceptance** - AHJ inspection, certificate ## Key Code Requirements | Requirement | Code Reference | Notes | |-------------|----------------|-------| | Elevator safety | ASME A17.1 | Safety Code for Elevators | | Inspection procedures | ASME A17.2 | Guide for Inspection | | Existing elevators | ASME A17.3 | Retroactive requirements | | Platform lifts | ASME A18.1 | Stairway lifts, VPLs | | Building code | IBC Chapter 30 | Number required, accessibility | | Hoistway enclosure | IBC Chapter 7 | Fire rating, openings | | Accessibility | ADA / ICC A117.1 | Size, controls, signals | ## Fire Service Operation ### Phase I (Automatic Recall) - Activated by lobby or machine room smoke detector - Elevators return to designated floor - Doors open and remain open - Visual signal indicates recall active ### Phase II (Manual Firefighter Operation) - Activated by key switch in car - Constant pressure door control - Independent car operation - Fire service key required (FEO-K1) ## ADA Accessibility Requirements | Element | Requirement | |---------|-------------| | Door width | 36" minimum clear opening | | Platform size | 80" x 54" minimum (2,000 lb car) | | Control height | 54" max (side reach), 48" max (front reach) | | Buttons | ¾" minimum, raised, Braille | | Floor designations | 2" raised characters, 60" height | | Hall lanterns | 2½" minimum, visible from call button | | Door timing | Based on 1.5 ft/sec travel speed | ## Testing Requirements | Test Type | Frequency | Scope | |-----------|-----------|-------| | Category 1 | Annual | Visual, functional, fire service | | Category 5 | 5 years | Full load, safety test, buffer test | | Acceptance | Initial | All systems, AHJ witnessed | | Fire service | Annual | Phase I and II operation | ## Common Elevator Issues | Issue | Cause | Resolution | |-------|-------|------------| | Pit water | Waterproofing failure | Repair waterproofing, verify sump pump | | Rail misalignment | Structural movement | Resurvey, realign rails | | Door problems | Interlock, operator, sill | Clean sills, adjust operator | | Leveling issues | Controller, encoders | Adjust leveling circuits | | Fire recall fails | Smoke detector, wiring | Verify detector zones, test circuits | | Noise/vibration | Isolation, alignment | Check mounts, realign | ## Turnover Requirements - [ ] Final inspection complete (AHJ) - [ ] Certificate of operation posted - [ ] All keys provided (fire service, access, independent) - [ ] O&M manuals delivered - [ ] As-built drawings delivered - [ ] Building staff training complete - [ ] Warranty documentation - [ ] Maintenance contract executed - [ ] Emergency procedures established - [ ] Monitoring service active ## Long-Lead Items | Item | Lead Time | |------|-----------| | Elevator equipment | 12-20 weeks | | Custom cab finishes | 8-12 weeks | | Specialty fixtures | 6-10 weeks | | Glass entrances | 6-8 weeks | ## Reference Files ### Elevator Types - [Traction Elevators](references/traction-elevators.md) - Geared, gearless, MRL systems - [Hydraulic Elevators](references/hydraulic-elevators.md) - Conventional, holeless, roped - [Specialty Elevators](references/specialty-elevators.md) - Destination dispatch, freight, LULA, dumbwaiters ### Components & Construction - [Elevator Components](references/elevator-components.md) - Machines, controllers, safeties - [Hoistway Construction](references/hoistway-construction.md) - Enclosure, rails, venting - [Pit & Machine Room](references/pit-machine-room.md) - Requirements, layout, access - [Doors & Entrances](references/doors-entrances.md) - Types, operation, finishes - [Cab Finishes & Fixtures](references/cab-finishes-fixtures.md) - Interiors, controls, signals ### Performance & Safety - [Elevator Performance](references/elevator-performance.md) - Speed, capacity, ride quality - [Fire Service & Emergency](references/fire-service-emergency.md) - Phase I/II, shunt trip - [Accessibility - ADA](references/accessibility-ada.md) - Compliance requirements - [Safety Hazards](references/safety-hazards.md) - Construction, operational hazards ### Coordination & Compliance - [Coordination & Installation](references/coordination-installation.md) - Structural, electrical, MEP - [Code Compliance](references/code-compliance.md) - A17.1, IBC, inspection process - [Testing & Inspection](references/testing-inspection.md) - Acceptance, periodic testing - [Maintenance & Turnover](references/maintenance-turnover.md) - Contracts, training, closeout ### Additional Systems - [Escalators & Moving Walks](references/escalators-moving-walks.md) - Types, installation, safety - [Specifications - CSI](references/specifications-csi.md) - Division 14, bidding ## Related Skills - **structural-trades** - Pit, hoistway, and machine room construction - **electrical-systems** - Power, disconnect, lighting coordination - **fire-protection-systems** - Sprinklers, shunt trip, fire alarm interface - **construction-safety-management** - Fall protection, LOTO procedures - **vdc-bim-coordination** - Elevator coordination, clash detection - **procore-project-management** - RFI, submittal, daily log workflows - **schedule-management-cpm** - Elevator installation sequencing - **quality-control-closeout** - Acceptance testing, commissioning - **building-envelope-exterior** - Hoistway venting coordination
GitHub에서 보기