| name | interconnection-impact-mitigation |
| description | Senior power-engineer playbook for screening and mitigating the grid impact of a new generator, storage, or large-load interconnection. Use whenever the question is whether X MW can connect at a point of interconnection and what upgrades it needs. Triggers on "interconnection study", "system impact study", "POI", "can we connect this plant at bus Y", "short-circuit ratio", or "weak grid". Walks from steady-state screens through weak-grid and reactive checks to the binding constraint and its mitigation set. |
Interconnection impact mitigation
Start with a defined injection: MW and MVAr capability, the point of interconnection (POI), and the dispatch scenarios to study.
Preferred action order
- Pin down the study scenario set: peak and off-peak cases, high-renewable dispatch, and the prior-queued projects that must be modeled as in-service.
- Run steady-state screens with the addition: base case and N-1 power flow, thermal loading and voltage screens around the POI. Route violations to
thermal-overload-mitigation and voltage-violation-mitigation for the corrective toolkit.
- Check weak-grid risk for inverter-based resources: short-circuit ratio at the POI. Low SCR (roughly below 3, critical below 2) flags control-interaction and stability risk — consider grid-forming controls, synchronous condensers, or POI relocation.
- Verify reactive capability and voltage control: power-factor range and voltage ride-through at the POI against the applicable interconnection requirements.
- Identify the binding constraint and assemble the mitigation set: network upgrades, an output-limitation or curtailment agreement, reactive devices, or phased interconnection — sized to the smallest set that clears the binding screen.
Working rules
- Screen with linear tools (PTDF on the injection) before full N-1 reruns; confirm the short list in AC.
- The fault contribution of the new plant changes breaker duty nearby; screen it and route over-duty to
short-circuit-mitigation.
- Restudy after any material change in plant size, POI, or queue assumptions — interconnection results do not transfer between scenarios.
- Separate "needed to connect safely" from "needed to deliver full output" — reliability upgrades and deliverability upgrades have different urgency and cost allocation.
Deliver
- The injection studied (MW, POI, scenarios) and the screens it passed.
- The binding constraint with numbers (element, loading or voltage, contingency).
- The recommended mitigation set and what must be restudied if assumptions move.
